Go to your analog input section in your eo1 and put the values seen on the eo1 screen shot (click on pic for large view). Take the white wire from the external harness and hook it up to the channel 1 or channel 2 of the LM-1 Output. Take your LM-1 and program it so the values are as those seen in the LM-1 software picture seen on this page (click for larger view). You want to program BOTH channel 1 and channel 2 . The reason being is that you dont know on the external jack, which of the two wires is channel 1 or channel 2. So just program them both that way you can hook up any of the two to your eo1 white wire. The eo1 will not always be identical to the LM-1. It might be like .2-.3 off. This is due to a slight delay in the circutry. It should be consistent though when you data log as far as RPM vs AFR. |